Filigree Flower Jewlery Set V.3
|
©Copyright 2007 Anna Ness
Notice: This pattern and photos and anything made from these patterns are for your personal use only and may not be copied, reproduced, altered or redistributed in any form without the written permission of the copyright holder. All Rights Reserved.
www.lullabiesandlace.com
Supplies:
- 28 gauge jewelry wire
- Size 2 ( mm) steel crochet hook
- 30 size 10 beads
- 2 ear rings
- necklace clasp
Special Stitches:
Beaded Chain (bch) – bring bead up against hook, YO, pull through loop on hook. Bead will be on the outside of the ch just made.
Beaded Single Crochet (bsc) – insert hook in st indicated, YO, pull through st, bring bead up against hook, YO and complete as regular sc.
Skill Level
Easy/Intermediate (this pattern is rated as Easy/Intermediate due to the fact that it uses wire and beads instead of yarn/thread. It uses simple stitches so once the technique of crochet with wire is gotten, the pattern is fairly easy to finish.
Earring (make 2)
Rnd 1 – String 10 beads onto wire before beginning, ch 2, work 5 bsc in 2nd ch from hook.
Rnd 2 – Sc in first bsc, ch 2, work bch, ch 2, sc in next bsc, * ch 2, work bch, ch 2, sc in next bsc from Rnd 1, repeat from * around, sc in first sc to join.
Fasten off with wire cutters about 2” from flower. Weave end through loop on earring and in last sc completed on flower several times. Fasten off with wire cutters and pinch end in so it cannot cut anyone.
Repeat for second earring.
Necklace
Side 1 – String 10 beads onto wire before beginning, leaving a 2” tail ch 52.
Rnd 1 (of flower) – 5 bsc in 2nd ch from hook.
Rnd 2 (of flower) - Sc in first bsc, ch 2, work bch, ch 2, sc in next bsc, * ch 2, work bch, ch 2, sc in next bsc from Rnd 1, repeat from * around, sc in first sc to join.
Side 2 – Ch 50.
Fasten off with wire cutters about 2” from last ch. Weave both ends through loops on clasp and in last ch completed on necklace several times. Fasten off with wire cutters and pinch ends in so they cannot cut anyone.
|
